TY  - BOOK
AU  - Cristobal, Zaren Daicel A. 
TI  - Design, fabrication, and testing of a laboratory-scale 1-4 shell and tube heat exchanger / 
PY  - 2024///
CY  - City of Batac
PB  - MMSU
N1  - UTHESIS ( Bachelor of Science in Chemical Engineering); Bibliography: leaves 76-79
N2  - The study was primarily conducted to design, fabricate, and test a laboratory scale 1-4 shell-and-tube heat exchanger (STHE) for school applications. The shell and  tube equipment were constructed from 304 stainless steel, with a with an outside  diameter of 260 mm (about 10.24 in), equipped with 44 Type 202 stainless steel tubes,  with each tube being 4 feet in length, having 0.5 inch outside diameter, 0.44 inch inside  diameter, and 1.5 mm thickness. The 1-4 STHE also featured tured fixed channel  covers and fixed-tube sheet also constructed using 202 stainless steel sheet/tube. The  layout of the tubes is arranged in 60° triangular pattern with a tube pitch of 0.75 inch  and tube clearance of 0.25 inch. The tubes were supported in place by 3 baffles with  spaced 12 inches between each other. Hot water at 95°C was the reference for the tube  side inlet, and it leaves the STHE at 85°C. The target temperature for the water in the  shell side was 50°C, from a shell inlet temperature of 25°C. Accessories such as  thermocouples, pump, pipe, and hose were installed to test the STHE. Results of the  study revealed that the fabricated STHE could heat the shell side fluid to a certain  temperature given a certain amount of time but, the calculated average of qloss is equal  to 26.86 kW and an efficiency of 52.9%.
ER  -